- After you got your Raspberry Pi 3, 2 Model B 1GB & B+, you might have enjoyed the open source function and code, but don't forget this, they are also able to interact with external hardware as embedded system.
- This 40Pin GPIO Extension Board is already soldered and assembled. so buyer just need to plug it in, then there you go
- This 40Pin GPIO Extension Board is already soldered and assembled. so buyer just need to plug it in, then there you go!
Product description
This 40Pin GPIO Extension Board is already soldered and assembled. so buyer just need to plug it in, then there you go! The Raspberry Pi B+ has landed on the Maker World like a 40-GPIO pinned, quad-USB ported, credit card sized bomb of DIY joy. And while you can use most of our great Model B accessories by hooking up our downgrade cable, its probably a good time to upgrade your set up and accessorize using all of the Model B+'s 40 pins. Package List Includes : (1) 220 Ohm Resistor x8 (2) 1k Ohm Resistor x5 (3) 10k Ohm Resistor x5 (4) 100k Ohm Resistor x5 (5) 1M Ohm Resistor x5 (6) 5.1M Ohm Resistor x5 (7) 5mm RGB LED x1 (8) 5mm Red LED x2 (9) 5mm Green LED x2 (10) 5mm Yellow LED x2 (11) USB Cable x1 (12) 5V Relay x1 (13) Jumper Cable Wires x65 (14) 1602 LCD Display Module x1 (15) Active Buzzer x1 (16) Rectifier Diode x2 (17) Switching Diode x1 (18) Tilt Sensor/Switch x1 (19) 6x6x4.3 Push Button x2 (20) Field Effect Transistor x1 (21) NPN Small Signal Transistor x2 (22) Thermistor Temperature Sensor x1 (23) Tower Pro Micro Servo 9g (SG90) x1 (24) Potentiometer(Adjustable Resistor) x1 (25) 400 Tie Points Solderless Breadboard x1 (26) Light Dependent Resistors(Sensor) x1 (27) New 40-Pin GPIO Extension Board x1 (28) 40-Pin GPIO Ribbon Cable for B+ & Pi2 x1
OkaeYa 40-Pin T-Cobbler GPIO Extension Board with LCD 1602 and Micro Servo Motor Starter Kit for Raspberry Pi 3 Model B 1GB & B+
- Brand: OkaeYa
- Product Code: OkaeYa -Extension Board
- Availability: Out Of Stock
-
Rs.2,901.00
- Reward Points: 5